Automatic Holy Water Dispenser

Automatic Holy Water Dispenser

• Holy water dispenser operated by pedal.
• Fully mechanical operation without connection to current.
• Soft pressure pedal system that avoids contact of the user's hand with the dispenser.
• Doser with controlled output of Holy Water.
• Collection tray to prevent the Holy Water from falling to the ground.
• Made of galvanized steel with a bronze-colored finish.
• Possibility of anchoring to the ground.
• Removable tank with capacity for 1 l. (Enough for approximately 700 - 800 people).
• A brush for donations can be incorporated with a key lock.
• Includes the texts "Holy Water".

Measurements and weight of the Holy Water dispenser

The automatic Holy Water font has:

• 120cm of total height including the Cross.
• 43cm maximum width in the Holy Water collection tray.
• 31cm maximum depth in the Holy Water collection tray.
• 35 cm base. wide by 25 cm. background.
• Approximate weight of 17 kg.

Installation of the automatic bender

The anti-covid benditera has a very simple installation process since it works completely mechanically, that is, it does not need to be close to any battery or power outlet.

In Religious Articles Brabander we start the manufacturing process of the battery once you make the purchase of the automatic Holy Water dispenser.

After finishing the manufacturing phase, the first thing is to check that everything works correctly. All the mechanical mechanisms are verified so that the Holy Water supply is correct. The approximate time for manufacturing and fine-tuning each of the benditeras is approximately 3-4 weeks.

Once the pertinent check has been made, the package is prepared for delivery. The blessing box is introduced in a special packaging that protects the piece from any damage it may suffer during the delivery process.

Once the package is received, the only thing the parish must do is:

1. Locate the benditera in the place where you consider appropriate.
2. Fill the reservoir-bottle with Holy Water.

With these two simple steps, everything is ready to be used by parishioners, priests, etc... in a totally hygienic and safe way.

The dispenser is designed to be placed without any kind of support. The 17 kg. of weight guarantee optimum stability. In any case, if desired, the base could be prepared to anchor the piece to the floor of the church.

Filling with Holy Water from the automatic dispenser

Filling the automatic benditera is very simple. It is a process that can be done in just a few minutes.

The upper part of the dispenser, where the Cross is located, is easily removable. Once this part is removed, you will find the Holy Water tank with the dispenser.

The tank is removed and separated from the dispenser by a thread. Once separated, it is filled in a tank with Holy Water.

The tank has an approximate capacity of 1 litre. This amount of Holy Water should be enough for between 700-800 people to cross themselves, sign themselves and cross themselves.

Use the automatic dispenser to cross, sign and sign the sign of the cross

The mechanical operation of the benditera allows a very intuitive use. Its mechanism is based on using the pedal located on the front of the dispenser to exert pressure on the dispenser. With this pressure, the dispenser lets out a sufficient quantity of Holy Water to make the sign of the cross, sign oneself and cross oneself.

In summary, the process is as follows:

1. Place the fingers of the right hand near the dispenser. It is important that the fingers do not come into contact with the dispenser to avoid possible risks of transmission of the coronavirus.
2. When the fingers are in position, press the pedal lightly.
3. Once we notice the Holy Water withdraw from the dispenser without touching any of its components.